Sun StorEdge[tm] 6020/6120 Array: Repair Procedures
This section provides the most common repair procedures for the
6020/6120. The repair procedures are provided in the following manual:
 Sun StorEdge
6020 and 6120 Arrays System Manual
The table below provides the section and page number that each procedure begins
on.
|
Component
|
Section / Page Number
|
Tips
|
| Chassis |
114 - 120
|
|
| Controller Card |
111 - 114
|
- Sun StorEdge 6120 Arrays and 6320 Systems may reset due to a Controller
Board SRAM timing issue (FIN I1043-2).
|
| Disk Drives |
100 - 102
|
-
Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (FIN I1136-1).
- During power on (cold boot), one or more drives may come up in an
offline state (FIN I1009-2)
-
Seagate Cheetah 7 FC-AL and SCSI disk drives with serial numbers
below 60000 are experiencing a higher than expected failure rate due to a spindle
motor issue (FCO A0239-1).
|
| Interconnect Cards |
109 - 111
|
|
| Power and Cooling Units |
102 - 106
|
- StorEdge 6020/6120 Arrays may automatically power themselves up after
being placed in standby mode (FIN I1002-1).
|
| UPS Battery |
106 - 108
|
|
| 
